FUTABA T18MZ FASSTest-2.4GHz - S.BUS Installation

30
<Before Use>
S.BUS Installation
This set uses the S.BUS system. The wiring is as simplified and clean mounting as possible, even with
models that use a large number of servos. In addition, the wings can be quickly installed to the fuselage
without any erroneous wiring by the use of only one simple wire, even when there are a large number of servos
used.
●When using S.BUS, special settings and mixes in your transmitter may be unnecessary.
●The S.BUS servos and S.BUS gyros memorize the number of channels themselves. (Settable with the
T18MZ)
●The S.BUS system and conventional system (receiver conventional CH used) can be mixed.
Receiver:R7008SB
Battery:FR2F1800(Optional)
Switch:HSW-L
Throttleservo:S9070SB(Optional)
Aileronservo:BLS174HV×2(Optional)
Elevatorservo:BLS171HV×2(Optional)
RudderServo:BLS175HV×1(Optional)
HAB×3(Optional)

Receiver:R7008SB
Servo:S3171SB×9(Optional)
HUB×4(Optional)
S.BUS GliderUsageexample
S.BUSAerobaticAirplaneUsage
example