FUTABA T18MZ FASSTest-2.4GHz - Page 98

98
<Linkage Menu>
Procedure for changing the slot No. of each sensor unit
1. Select [Sensor] on page 2 of the Linkage Menu.
2. Call page 2 by pressing [1/2] and press [Change Slot].
3. Connect the receiver battery and the sensor unit to the S.I/F
connector behind the rear cover of the transmitter using a 3-way
hub or 2-way cord.
4. Press the [Read] key. The current slot No. is displayed.
5. When a number is pressed, the [ △ ], [ ▽ ], [ △△ ] and [ ▽▽ ]
keys appear. Now change the desired No.
6. When the [Write] key is pressed, the desired No. is written to the
sensor
●Call this screen by switching to page 2 by
pressing the [1/2] button on the Sensor
screen and then pressing [Change Slot].
●When pressed, the current slot No. is
displayed.
●The slot No. is written to the sensor.
●Returns to the Sensor screen.
Sensor
HUB
orY-adapter
Receiverbattery
T18MZ