Section 50 00-02-1032
2020-12-08 - 1 -
Introduction
Product Description
The Centurion configurable controller is a display and controller combination expressly designed to meet the
requirements of three specific kinds of applications:
Screw Compressors
Reciprocating Compressors
Pumps
The heart of the Centurion system is the main input/output (I/O) module or controller, which can be mounted on a
standard DIN rail. While it is designed to work with any Modbus (Master) compliant HMI (Human Machine
Interface) or with no operator interface at all, it is optimally configured and field-configurable using the Centurion
Configuration Tool, powerful software developed to configure the controller. Parameters can be modified in the
field without special need for laptop or software by utilizing FW Murphy’s specially programmed M-VIEW
controller display.
The controller is designed to monitor, control, protect and optimize small- to medium-sized gas operated
compressors and pumps in the field. Proper operation is maintained by monitoring set points and digital, analog
and temperature input points and providing the logic to take corrective and/or proactive steps.
The controller also allows for controlled shutdown and no-flow monitoring as well as auto startup and engine
control capabilities.
The controller provides real-time data via communications ports to a connected display and/or supervisory
system. This advanced system offers multiple options for remote communications and operation. The industry
standard Modbus RTU or Modbus TCP/IP protocol means greater support for a wide variety of communication
equipment including radio and satellite communications systems.
Modbus RTU Register Map
Application-specific map is contained in the panel sequence of operation documentation. Contact factory
representative to obtain documents if needed or see www.fwmurphy.com for the Centurion C5-1 Modbus
Application Guide and Map.
To Next Page
Loading...
Need help?
General
