G-Technology G Speed studio - Changing Buzzer Settings

p. 42
Conguring G-SPEED Studio R
• 10GBTruncate
• GrpRounding
• TableRounding
Write Back Cache Flush Interval – Enter a value into the field from 1 to 12 seconds.
Enclosure Polling Interval – 15 to 255 seconds.
• Adaptive Writeback Cache – Check the box to enable or uncheck to disable.
• Forced Read Ahead – Check the box to enable or uncheck to disable.
• Pilot LED Brightness – High, Medium, Low, O
• Enable HDD Park Ahead(Level 1)
• HDD Park Ahead Interval (10-1440)
• Enable HDD Low Rotation Speed (Level 2)
• HDD Low Rotation Speed Interaval (10-1440)
• Enable HDD Idle Spin Down(Level 3)
• HDD Idle Spin Down Interval (10-1440)
3. Click the Save button.
4. Click the X icon to close the settings panel.
Changing Buzzer Settings
To change buzzer settings:
1. From the Dashboard icon, select Controller.
2. Mouse-over the buzzer, then click the Settings button.
3. Check the Enable Buzzer box to enable the buzzer or uncheck the box to disable.
4. Click the Save button.