GCC Technologies EXPERT 24 LX - Automatic-Aligning System; Introduction

Expert 24 LX User Manual
Automatic-Aligning System
5-1
Chapter 5 Automatic-Aligning System
Please note that this chapter is only an instruction to AASII; for step-by-step instructions, please
refer to the following chapters: 07_A-3 CorelDraw Plug-In, 07_A-4 GreatCut, 07_A-5 Illustrator.
5.1 Introduction
The Expert 24 LX cutting plotters feature a standard Automatic-Aligning System (AAS II) to
guarantee precise contour cutting quality by detecting the registration marks printed around the
graphic.
Notice
 Avoid any kind of light source horizontally illuminating the AAS module.
- PROHIBITED - ACCEPTABLE
 DO NOT take off the cover of AAS module while in operation.
- PROHIBITED