QUICK MENU
1. Power ON. (The POWER LED lights on)
2. Note: Make sure the level is up before placing the media on the plotter. Place the
media and pull the level to lower down the pinch rollers (must be sure the pinch
rollers are position above the grid drums, that is, within the white marks).
3.
Puma II will take about 10 sec to initialize the machine. Then the
cutter will size the media automatically according to set of the dip switch (usually
the presetting is EDGE media type).
4. Off-line condition – Plotter is not ready to receive data from computer. Press
ON/OFF LINE key, the LED above the key turns off.
5. On-line condition - Plotter is ready to receive data from computer. Press
ON/OFF LINE key, the LED above the key lights.
6. Change the setting value during cutting. Press PAUSE key, the LED above the
key flashes. To continue cutting press ON/OFF LINE key.
7. Terminate the cutting and clear the data in the buffer. Press ON/OFF LINE key or
PAUSE key and then press DATA CLEAR key.
II
To Next Page
Loading...
