Warming 2. HPGL/2 command error
If your cutting plotter cannot recognize the commands from your computer, please
check the commands applied to your cutting plotter are HP-GL/2 or HPGL command.
Then send the same cutting job to plotter again.
If it shows the same result, please contact customer service personnel.
Warming 3 Lever up or no media
Check if you lower down the lever and be sure to load the media before cutting.
Warming 4 Cannot repeat cutting
This Error comes from two possibilities:
1. The buffer holds no data: please send a new graph from computer;
2. The buffer is full: please sending the same cutting job from the computer again.
In both conditions, press ON/OFF LINE key to clear the warming message.
Warming 5 Communication error
Check if the serial/USB/parallel cables have been connected to both cutting plotter
and computer properly.
If yes, then check whether the interface setting is correct.
Check communication setting of your PC are the same to the setting on your cutter(for
example – 9600bps, no parity, 8 bits, 1 stop bit). Then, press ON/OFF Line key to
switch to on line condition.
Warming 6 Width sensor error
Check if the pinch rollers are positioned above the grid drum and reload the media
again.
Note:
In order to identify the warming easily, please stick the warming sticker
(which we put in accessory box) on the side cover of your cutter.
Puma II Users Manual 6-3
To Next Page
Loading...
