Simon XT
User Manual
10
Subdisarm
1. Enter the master code while the system is disarmed.
2. The panel displays and speaks Subdisarmed, the Disarm button blinks, and the panel beeps once.
3. When you’ve finished accessing the temporarily unprotected areas, press Disarm to return to
Disarmed.
Disarm (off)
1. Press Disarm, then enter your code when the panel displays Enter code.
2. The panel displays and speaks Disarmed, the Disarm button lights up, and the panel beeps once.
Arming doors and windows (Stay)
1. Ensure that all doors and windows are closed.
2. Press Stay, then enter your code when the panel displays Enter code, if a code is required.
3. The panel displays Stay, speaks Stay, and the Stay button lights up.
4. The panel starts an exit delay, and sounds exit beeps in groups of 2 until the exit delay expires.
Arming doors, windows, and motion sensors (Away)
1. Press Away, then enter your code when the panel displays Enter code, if a code is required.
2. The panel displays Away, speaks Away, and the Away button lights.
3. The panel starts an exit delay and sounds exit beeps in groups of four until the exit delay expires.
Exit/entry delay
Your Simon XT provides a delay after entering or exiting your home before the system is alarmed. Table 5
provides details for the entry and exit delay features.
Table 5. Entry and exit delay details
Function Description
Entry delay Some active sensors cause immediate alarms when tripped. Other sensors, if enrolled in a delayed
response group, start an entry delay that lets you enter the premises and disarm the system. If the
system has not been disarmed by the end of the entry delay, the alarm occurs.
No delay If the system was armed with the no delay feature activated, there will be no entry delay and the
alarm will occur immediately.
Exit delay When the user arms the system, an exit delay starts. During the delay the user can vacate the
premises through a delayed response door without causing an alarm.
Protest during arming The system may protest an arming level change if certain abnormal conditions exist. If a sensor that
is active in the requested arming level is open, the system sounds protest beeps and automatically
bypasses the open sensor (depending on system configuration).
To Next Page
Loading...
Need help?
General
