GE Security Simon XT User Manual

Chapter 2
Using the control panel
15
Using an offsite phone
If enabled by the installer, you can control your Simon XT panel remotely from an offsite phone. The panel
answers a phone call according to the dialing method programmed by your installer.
After a certain combination of rings and pauses, the panel will answer the call with the voice prompt Enter
your code. You must enter the correct code to gain access.
If you are interacting with your panel and the panel hangs up on you, the system is calling in a report to the
central monitoring station or remote phone due to an action by you or someone at the security system site. The
actions listed in Table 6 may be performed from an offsite phone.
Table 6. Phone controls
Action Phone keypresses Comments
Disarm
1
System not already disarmed
Subdisarm
1
Must have used the master code to gain access; system
was disarmed
Arm doors and windows (Stay)
2
Press 2 again to activate No delay feature
Arm doors, windows, and
motion sensors (Away)
3
Press 3 again to activate Latchkey feature
Check status
0
Turn light on * –<unit_num>. N = 1-8, unit number
Turn light off # –<unit_num>. N = 1-8, unit number
Turn all lights on
* – *
Turn all lights off
# – #
Hang up
9
2-way voice session
5
During session, pressing 1 turns speaker on, 3 turns
microphone on, 9 ends session (hangs up). If no keypresses
are heard by the panel for 90 seconds, it will hang up. After
each keypress, the panel will send a short tone.

GE Security Simon XT Specifications

General

Brand	GE Security
Model	Simon XT
Category	Security System
Language	English