GE Dash 4000 Operator's Manual

Monitoring ECG
2000966-386D Dash™ 3000/4000/5000 8-13
 Arrhythmia alarm levels
 HR, PVC and ST parameter alarm levels
 ECG SIZE
 DETECT PACE
 ARRHYTHMIA
 ST ANALYSIS
 LEAD ANALYSIS
 HR HIGH LIMIT and HR LOW LIMIT
 PVC LIMIT and PVC state
To select the source of ECG settings, follow this procedure.
1. Select MORE MENUS > MONITOR SETUP > MONITOR DEFAULTS >
SETUP DEFAULT DISPLAY.
2. Locate and select COMBO DEFAULT SOURCE.
3. Select one of the following:
 TELE DEFINED — Use the telemetry ECG settings. This is the factory
default.
 USER DEFINED — Use the monitor’s ECG settings if telemetry is NOT
admitted. Use the telemetry ECG settings if telemetry IS admitted.
ECG Setting Source When Entering COMBO Mode
The following tables indicate the source (monitor or telemetry) of ECG settings when
entering COMBO mode.
Notice that selecting Tele Defined means the ECG setting source is always telemetry
when entering COMBO mode, while the ECG setting source for User Defined
depends on whether the patient is admitted to the monitor or telemetry when entering
COMBO mode.
Tele Defined
Monitor Telemetry Entering COMBO Mode ECG Setting Source
Not admitted Not admitted >
Telem etryAdmitted Not admitted >
Not admitted Admitted >
User Defined
Monitor Telemetry Entering COMBO Mode ECG Setting Source
Not admitted Not admitted >
Monitor
Admitted Not admitted >
Not admitted Admitted > Telemetry

GE Dash 4000 Specifications

General

Resolution	640 x 480 pixels
Power Supply	100-240 VAC, 50/60 Hz
ECG	3/5/12-lead
IBP	Up to 4 channels
Battery Backup	Yes
Certifications	CE, UL, CSA
Parameters Monitored	ECG, SpO2, NIBP, IBP, Temperature, Respiration, Cardiac Output
Connectivity	Ethernet, USB, Serial
Display Type	TFT LCD
Recorder	Integrated thermal printer
Battery Type	Lithium-ion
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Humidity Range	15% to 95% non-condensing
Display Size	10.4 inches
Cardiac Output	Available