Managing Patients
2000966-386D Dash™ 3000/4000/5000 5-5
Control Settings
To adjust the control settings for the patient admitted to the monitor, select MORE
MENUS > ADMIT MENU. Then select any of the following options and make the
desired changes.
NOTE
All changes are temporary and revert to the factory or custom defaults when the
patient is discharged. To permanently change the these settings, refer to Defining
Custom Defaults on page 3-7.
Option
Monitoring
Mode
Patient-Monitor
Type
Function
CHANGE ADMIT INFO
All
1
All
2
Select the patient information.
NOTE
When monitoring ECG, entering the sex and age of the patient
provides information needed for the 12SL with Gender-
Specific Analysis or ACI-TIPI algorithms.
NOTE
If you change any patient information requested from a Lab
Access Server, notify the appropriate hospital personnel.
REQUEST ADMIT INFO All All Request patient information from a Lab Access Server with an
interface to hospital information.
NOTE
Use the VIEW MANUAL ADMIT INFO menu option to review
the manually entered information separately from the
automatically populated information.
RECALL DEFAULT All All Recall factory defaults.
ADMIT HELP All ADULT-ICU and
NEONATAL-ICU
Review the patient information required to admit a patient for the
current monitoring mode.
ADMIT PATIENT All ADULT-ICU and
NEONATAL-ICU
Admit a patient to the monitor with the information entered on the
MANUAL ADMIT INFORMATION information window.
NEW CASE All OPERATING
ROOM
Discharge the existing patient data and ready the monitor for the
next patient admission.
UNITS OF MEASURE All All Select the units of measure for the patient’s age, height and weight.
SET UNIT NAME ROVER and
ROVER
COMBO
All Select the unit name for network identification.
SET BED NUMBER ROVER and
ROVER
COMBO
All Select the bed number for network identification.
PRINT LOCATION ROVER and
ROVER
COMBO
All Select writers from the network.
To Next Page
Loading...
Need help?
General
