Programming Site Data 1-15
March 2008
Procedure Options After completing the above steps, the meter returns to the Channel
PROGRAM
prompt. Continue as follows:
• To continue programming the meter, refer to the menu maps in
Appendix A and navigate to the desired menu. Then, proceed to
the appropriate section of this manual for instructions.
• To leave the Channel PROGRAM and retain the previous settings,
press
[EXIT] twice and then press [F1] = NO at the SAVE prompt. Any
programming changes will be discarded and you will be returned
to the data display
.
• To leave the Channel PROGRAM and return to measurement mode,
press
[EXIT] twice and then press [F2] = YES at the SAVE prompt. Your
programming changes will be entered into the meter’s memory,
and you will be returned to the data display
.
To Next Page
Loading...
