Programming Site Data 1-41
March 2008
Entering Global System
Data
While following the programming instructions, refer to the menu map
in Figure A-5 on page A-5.
1. To enter the
GLOBAL menu, press [F3]=GLOBL.
2. To enter the SYSTM submenu, press [F2]= SYSTM.
3. At the System Units prompt, press
[F1] to display parameters and
measurements in English units or press
[F2] to display parameters
and measurements in metric units.
4. At the Totalizer Option, press
[F1] to measure totals automatically
or press
[F2] to measure totals manually.
If
AUTO is selected above, the meter automatically begins totalizing
upon leaving the User Program. If
MNUAL is selected, the console key
on the keypad may then be used to start and stop the totalizer.
The manner in which the totalizer responds to an error condition may
be set in the
I/O submenu.
5. Use the [←], [→] and
[F1]-[F4] keys to select the desired
Volumetric Units for the flow rate display.
Note: The above option bar shows English units, as an example.
The abbreviations and definitions of all the available volumetric units
are shown in Table 1-15 on page 1-42. The choices shown on the
option bar are determined by the selections made at the previous
System Units prompt screen.
To Next Page
Loading...
Need help?
General
