March 2008
1-40 Programming Site Data
Procedure Options After completing the above steps, the meter returns to the Global
PROGRAM
. Continue as follows:
• To continue programming the meter, refer to the menu maps in
Appendix A and navigate to the desired menu. Then, proceed to
the appropriate section of this manual for instructions.
• To leave the User Program and retain the previous settings, press
[EXIT] twice and then press [F1] = NO at the SAVE prompt. Any
programming changes will be discarded and you will be returned
to the data display.
• To leave the User Program and return to measurement mode, press
[EXIT] twice and then press [F2] = YES at the SAVE prompt.Your
programming changes will be entered into the meter’s memory,
and you will be returned to the data display.
To Next Page
Loading...
