GE F650 - Page 397

7-28 F650 Digital Bay Controller GEK-106310AB
7.2 IEC 61850 PROFILE FOR F650 7 IEC 61850 PROTOCOL
7
2.2.2 PTOC (Time overcurrent)
2.2.2.1 phsPTOC
This logical node class is used for phase time overcurrent and has 6 instances inside the device.
Note: ACT includes origin attribute in ST, this is implemented according to Tissue 68.
2.2.2.2 ndPTOC
This logical node class is used for neutral time overcurrent and has 3 instances inside the device.
Note: ACT includes origin attribute in ST, this is implemented according to Tissue 68.
PTOC class
Attribute
Name
Attribute
Type
Explanation M/O/E Notes
PTOC Time overcurrent
Data
Common Logical Node Information
Mod INC Mode M Status-only
Beh INS Behaviour M
Health INS Health M
NamPlt LPL Name plate M
Status Information
Str ACD Start M TOC PKP
Op ACT Operate M TOC OP
Blk ACT Block E TOC BLK
Settings
TmACrv CURVE Operating curve type M Curve
StrVal ASG Start value O Pickup Level (0,05 - 160)
TmMult ASG Time dial multiplier O TD Multiplier (0 – 900)
RsMod ING Reset Mode E Reset (instantaneous, lineal)
InMagTyp ING Input Type E Input (Phasor, RMS)
VolRst SPG Voltage Restraint E (enable, Disable)
PTOCEna SPG Function TOC enable E Function
PTOC class
Attribute
Name
Attribute
Type
Explanation M/O/E Notes
PTOC Time overcurrent
Data
Common Logical Node Information
Mod INC Mode M Status-only
Beh INS Behaviour M
Health INS Health M
NamPlt LPL Name plate M
Status Information
Str ACD Start M TOC PKP
Op ACT Operate M TOC OP
Blk ACT Block E TOC BLK
Settings
TmACrv CURVE Operating curve type M Curve
StrVal ASG Start value O Pickup Level (0,05 - 160)
TmMult ASG Time dial multiplier O TD Multiplier (0 – 900)
RsMod ING Reset Mode E Reset (instantaneous, lineal)
PTOCEna SPG Function TOC enable E Function