GE F650 - Page 398

GEK-106310AB F650 Digital Bay Controller 7-29
7 IEC 61850 PROTOCOL 7.2 IEC 61850 PROFILE FOR F650
7
2.2.2.3 gndPTOC
This logical node class is used for ground time overcurrent and sensitive ground time overcurrent. There are 6 instances
inside of this logical node inside the device.
Note: ACT includes origin attribute in ST, this is implemented according to Tissue 68.
2.2.3 PTOF (OverFrequency)
This logical node class is used for overfrequency and has 6 instances inside the device.
Note: ACT includes origin attribute in ST, this is implemented according to Tissue 68.
PTOC class
Attribute
Name
Attribute
Type
Explanation M/O/E Notes
PTOC Time overcurrent
Data
Common Logical Node Information
Mod INC Mode M Status-only
Beh INS Behaviour M
Health INS Health M
NamPlt LPL Name plate M
Status Information
Str ACD Start M TOC PKP
Op ACT Operate M TOC OP
Blk ACT Block E TOC BLK
Settings
TmACrv CURVE Operating curve type M Curve
StrVal ASG Start value O Pickup Level (0,05 – 160)
TmMult ASG Time dial multiplier O TD Multiplier (0 – 900)
RsMod ING Reset Mode E Reset (instantaneous, lineal)
InMagTyp ING Input Type E Input (Phasor, RMS)
PTOCEna SPG Function TOC enable E Function
PTOF class
Attribute
Name
Attribute
Type
Explanation M/O/E Notes
PTOF OverFrequency
Data
Common Logical Node Information
Mod INC Mode M Status-only
Beh INS Behaviour M
Health INS Health M
NamPlt LPL Name plate M
Status Information
Str ACD Start M TOF PKP
Op ACD Operate M TOF OP
Blk ACT Block E TOF BLK
Settings
StrVal ASG Start value (frequency) O Pickup Level (20-65)
BlkVal ASG Voltage Block Value O Minimun Voltage (10-300)
OpDlTmms ING Operate Delay Time O Trip Delay (0-900000)
Units in miliseconds
RsDlTmms ING Reset Delay Time O Reset Delay (0-900000)
Units in miliseconds
PTOFEna SPG Function TOF enable E Function (Enable,Disable)