FP1500 Installation, Configuration and Commissioning Manual 22
Figure 14. FP1500 keypad
4.1.1 General parameters
The alphanumeric LCD screen of the FP1500 has 4 lines of information of 40 characters
each.
[Screen title]: this reminds you at all times of the current screen.
[#Exit]: the <#> key takes you back to the previous menu
Index of menu actions: Numbered in accordance with the number of options. Key in the
number allocated to each action.
Adjust general parameters
*** ***
ALL CONNECTED DEVICES
ARE AT NORMAL STATE
00/00/0000 00:00
Any key
[MAIN MENU] [# Exit]
1. Configure 4. Connect 7. See
2. Test. 5. Disconnect 8. Day Mode
3. Time 6. Print 9. Codes
From the start screen, access option 1
<Configure>
[CONFIGURE] [# Exit]
1. System 4. System Op. 7. Events
2. See Config. 5. Check. Prog. 8. Day Mode
3. Time/Date 6. Power supply 9. Codes
If you are asked the code again, enter 9898.
Select option 4 <System Options>
Here, you can programme the parameters
[SYSTEM OPTIONS] [#Exit]
1. General
2. Messages
3. Modem
Language : [SPANISH]
Calibration time : [00:00]
LED Flashing : [YES]
Historic Mode : [NORMAL]
1. General
2. Messages
3. Modem
by following the indications.
1-[General]: This screen lets you programme:
Language: Press the < 9 > key to select the
language.
E.g. [SPANISH] < > [ITALIAN] < > [PORTUGUESE]
< >[ENGLISH]
Calibration Time: At the hour indicated, the
calibration of the sensors is automatically
To Next Page
Loading...