Loading the software
LOGIQ V3/V5/V5 Expert – Basic Service Manual 8-9
5726264-100 English Rev.8
8-3-7-1 Loading the C Disk with USB memory stick(continued)
4. Select one of the options for loading the system. Select
choice [1] to load the C disk only.
NOTE: During the upgrade process, Cursor works as left mouse
button and Set/B Pause works as right mouse button. It is
opposite from that in scanning screen.
• To select [1], only the bootable C: partition is loaded.
This option is intended for recovery of a system that will
not boot up. It is not recommended for application
software upgrade because during upgrade process, the
data on the system would possibly be impacted.
• To select [2], wipe tool: This option is to wipe tool all the
patient data.
NOTE: All the patient data cannot be recovered after wipe tool.
• To select [3], Service tool. The complete disk will be
loaded. This option is recommended for application
software upgrade.
NOTE: This option is used by service engineer only. It needs
password to continue, the password is GEWuXiChina
and it is case sensitive.
NOTE: When to select [3] to load complete disk, please ensure
that any patient data on the disk has been backed up.
• To select [4], Screen size. This option is to adjust the
size of screen display.
NOTE: All the patient data cannot be recovered after wipe tool.
If you select [3], ALL existing software and data will be erased.
If backup has not been performed, all data like Patient
Database, System Configuration and User Configurations
(Customer Presets) will be lost.
To Next Page
Loading...
Need help?
General
