5.7.2 Using HTTPS Time Synchronization
Time synchronization can also be configured to use an HTTPS web server's time by pulling it from the header of the web
page it serves. To configure HTTPS time synchronization, select the HTTPS Server radio button on the Time Sync
Configuration page, enter a valid HTTPS URL, and press the Save button. If a network proxy is in use, this time
synchronization method will only work with HTTPS URLs that do not require a network proxy in order to reach them.
If the new HTTPS URL was successfully configured after pressing the Save button, a success statement will be displayed and
the updated time will be displayed. If the time and date was more than 20 minutes out of date prior to time synchronization
occurring after pressing the Save button, the Web Console session may end and an error message may be presented indicating
that the session’s timeout had been reached. Log back into the Web Console to verify the time was updated as expected.
To Next Page
Loading...
Need help?
General
