GE MOA 280i - Page 209

GE Analytical Instruments ©2006 Index-9 DML 14291 Rev. A
printer........................................................................4-3
Printer .....................................................................4-14
printer output.........................................................1-10
Procedure for Tightening Swagelok Fittings 11-4
Pump Oil Menu........................................................4-18
Purge vessel..............................................................1-7
Purge Vessel
Bubbler Line.......................................................11-4
Connections of tubing to glassware ........... 11-3
Filter Line...........................................................11-4
IFD filter.............................................................11-2
NaOH gas bubbler trap.....................................11-2
Procedure for Tightening Swagelok Fittings
....................................................................... 11-4
Purge Line..........................................................11-4
Setup .................................................................11-2
Water Connections ...........................................11-5
R
Range of NOA............................................................6-9
reaction between nitric oxide and ozone............1-1
Reactions of NO
to form nitrate....................................................1-1
to form nitrite.....................................................1-1
with amines .........................................................1-1
withthiols.............................................................1-1
Reduction of Nitro-compounds............................13-1
reparation of the Nitrate Reducing Agent ..... 13-2
Replacing the Reducing Agent and Opening the
Purge Vessel..................................... 12-13, 13-11
Replicate gas calibration........................................6-7
Replicate zero gas calibrations................................. 6-4
Reporting Interval Menu..........................................5-8
Required Units for gas measurements..................5-8
response factors acceptable range........... 6-8, 16-10
response factors exceed the recommended limits
possible causes....................................................6-8
response factors out of range warning.................6-8
response factors too low
possible causes....................................................6-8
S
SAFETY WARNINGS ................................................1-3
Sample Flow Control Device.................1-6, 1-7, 4-13
frit restrictor........................................................1-7
Sample Inlet System.............................................. 1-6
Accurate NO™ Exhaled Breath Kit.....................1-7
Bag Collection and Sampling Kit.......................1-7
Gas Sampling Kit..................................................1-6
Purge vessel .........................................................1-7
Sampling Inlet Systems............................................1-6
Schematic of the 280i NOA.....................................1-6
Scrolling between Data and Warn shortcuts........3-5
Security................................................................. 15-14
Select Modes Menu.........................................5-5, 11-9
Sensitivity Menu................................................... 11-10
Septum Replacement ...........................12-14, 13-12
Serum and Plasma Samples................................ 13-10
Setting the Clock..................................................4-14
DATE and TIME Menu ....................................... 4-15
Setting the Consumables Installation Data...4-18
Setup Menu............................................4-15, 5-4, 11-9
Sievers calibration gas.............................................6-6
flow rate...............................................................6-6
Stability of NO in Mylar Bags
...........................8-15
Stand-by Mode...........................................................3-2
Start Mode .................................................................3-2
Start Sequence..........................................................3-3
display Status Screen..........................................3-4
Fail Test................................................................3-4
High Cell Pressure Check ...................................3-3
Low Cell Pressure Check....................................3-3
PMT Temeprature Check....................................3-3
PMT/Ozone test...................................................3-3
Supply Pressure Check........................................3-3
Start the NOA......................................................... 4-18
Startup Procedures for Nitrate Reduction .....13-3
Startup Screen ..........................................................3-3
Start-up Tests......................................................... 16-5
Cooler Temp.....................................................16-6
PMT Signal.........................................................16-6