GE MOA 280i - Page 210

GE Analytical Instruments ©2006 Index-10 DML 14291 Rev. A
Supply Pressure .............................................. 16-6
Status Screen......................................... 3-2, 3-8, 4-18
Cell Pressure........................................................3-2
Cooler Temperature...........................................3-2
PMT Signal............................................................3-2
Start Conditions ................................................4-19
Supply Pressure...................................................3-2
Stop Mode..................................................................3-2
Stop Sequence..........................................................3-6
Supply Pressure.................................................1-8, 3-5
Swagelok to barbed adapter................................4-13
T
Testing and Cleaning the Flow Restrictor Frit
..........................................................................15-13
Testing Bags for Pinhole Leaks........................ 8-17
Thermal Mass Flow Meter.....................................1-10
Thermal Mass Flowmeter................................1-6, 5-2
Time-out Function..................................................3-9
Tools..........................................................................4-2
Troubleshooting
Cell Pressure too High or too Low ...........16-10
clogged restrictor.............................................16-7
Errors
E 01 – Setup Data Corrupted, Check Before
Running.................................................. 16-2
Errors................................................................ 16-1
E 02 – Cell Pressure was Above the Limit
................................................................. 16-2
E 03 – Ozone Supply Pressure was Below
the Limit ................................................ 16-2
E 05 – Cooler Temperature Above the Limit
................................................................. 16-2
Errors and Remedies..................................... 16-2
Gas Sampling Problems..................................16-10
High Background after Calibration .........16-11
Liquid Measurements Problems....................16-11
Contaminatio..............................................16-13
Foaming of theVCl
3
Reagent...................16-13
Ghost Peaks...............................................16-14
Injection Technique..................................16-13
Leaks in Purge System..............................16-12
Low Conversion for Nitrat ........................16-12
Low Sensitivity ...........................................16-11
Poor Repeatability...................................16-12
Syringe Problems.....................................16-13
Liquid Measurements Problems High
background Signal and Rising Baselines 16-14
main fuse............................................................16-8
No Display.........................................................16-9
Blown Fuse....................................................16-9
Contrast Adjustment...................................16-9
Loose cables..................................................16-9
ozone fuse..........................................................16-6
Start-up Tests....................................................16-5
Cooler Temp...............................................16-6
PMT Signal...................................................16-6
Supply Pressure .........................................16-6
Vacuum Pump.............................................16-6
Warnings.............................................................16-3
W 09–Pump Oil Needs to be Replaced ..16-3
W 09–Pump Oil Needs to be Replaced Soon
..................................................................16-3
W 11–Hopcalite Needs to be Replaced .16-4
W 11–Hopcalite Needs to be Replaced Soon
..................................................................16-4
W 13–Reaction Cell Needs to be Cleaned16-4
W 13–Reaction Cell Needs to be Cleaned
Soon.........................................................16-4
W 15–Cooler Needs to be Serviced........16-4
W 16–Cooler Needs to be Serviced Soon 16-
4
Troubleshooting the NOA......................................16-7
No Power to NOA ............................................16-8
U
UNITED STATES REGULATORY REQUIREMENTS 1-
3
Units for response factors.......................................6-7
units for the offsets....................................................6-4