Monitor UV-900
User Manual 18-1120-05 Edition AF
43
Short instructions
The following short instructions are intended as a
guide for users who are fully familiar with the safety
precautions and operating instructions described in
this manual. The instructions assume that the unit is
installed according to the installation instructions.
1
Switch on the module
with the mains
switch on the rear panel.
2
Switch on the UV-lamp
by selecting
Run
.
3
Select wavelength
for one, two or three
wavelengths.
4
Autozero
the module by pressing
OK
.
5
The main operating menu
(RUN-menu)
is shown.
M
onitor U
V
-900
Select OK
ESC
Calibrating
Please wait...
End
Press OK to Run
Set Wavelength
(215, 254, 280 nm)
Set Wavelength λ1
(215nm)
Set Wavelength λ2
(254nm)
Set Wavelength λ3
(280nm)
Autozero
λ1(215) 1.123 AU
λ2(254) 0.02345 AU
λ3(280) 1.123 AU
To Next Page
Loading...
