GE MOTOR MANAGER 2 - Page 123

GE Power Management
MM2 Motor Manager 2 6-43
6 COMMUNICATIONS 6.6 DATA FORMATS
6
F19 Unsigned Integer: Unlatched / Latched FFFF
0 = Unlatched ---
1 = Latched ---
F20 Unsigned Integer: Auxiliary Relay
Function
FFFF
0 = Serial Control ---
1 = Trips ---
2 = Alarms ---
3 = Pre Contactor A ---
4 = Post Contactor A ---
5 = Post Contactor B ---
6 = Drive Available Manual ---
7 = Load Increase Alarm ---
8 = Undercurrent Trip ---
9 = Underpower Trip ---
10 = Keypad Reset ---
11 = Interlock 1 ---
12 = Interlock 2 ---
13 = Interlock 3 ---
14 = Interlock 4 ---
15 = Interlock 5 ---
16 = Interlock 6 ---
17 = Interlock 7 ---
18 = Interlock 8 ---
19 = Interlock 9 ---
20 = Interlock 10 ---
21 = AUTO Mode ---
22 = Motor Running ---
23 = Ground Fault Trip ---
24 = Wye Delta Closed Transition ---
25 = Autotransformer 2S ---
26 = Not Used ---
27 = Pre Contactor B ---
28 = Segregated Ground Fault Alarm ---
29 = Thermal Capacity Alarm ---
30 = Motor Available ---
31 = Motor Available Auto ---
32 = Overload ---
33 = Soft Starter Bypass ---
F21 Signed Integer FFFF
Table 6–13: DATA FORMATS (Sheet 5 of 15)
CODE DESCRIPTION BITMASK
F22 Command FFFF
1 = Reset ---
2 = Lockout Reset ---
3 = Stop ---
4 = Start A ---
5 = Start B ---
6 = AUX Relay 1 = On ---
7 = AUX Relay 1 = Off ---
8 = Clear Maintenance Timers ---
9 = Clear Maintenance Counters ---
10 = Clear Energy Data ---
11 = Display Message ---
12 = Simulate Keypress ---
13 = Manual Inhibit ---
14 = Manual Restore ---
15 = Not used ---
16 = Store New Address ---
17 = Upload Mode Entry 2 ---
18 = Upload Mode Entry 1 ---
19 = Reload Factory Setpoints 2 ---
20 = Reload Factory Setpoints 1 ---
21 = Test Relays and LEDs ---
22 = Clear Interlock Counter ---
23 = AUX Relay 2 = On ---
24 = AUX Relay 2 = Off ---
25 = Factory Use ---
26 = Factory Use ---
27 = Factory Use ---
28 = Factory Use ---
29 = Factory Use ---
30 = Factory Use ---
31 = Factory Use ---
32 = Factory Use ---
33 = Store Preset Values ---
34 = Start Inhibit (Block) ---
35 = Start Restore (Unblock) ---
Table 6–13: DATA FORMATS (Sheet 6 of 15)
CODE DESCRIPTION BITMASK