Geeetech A10M - Filament Run-Out Sensor (Optional)

52
SHENZHEN GETECH TECHNOLOGY CO LTD
(Picture 8-2)
8.3 Filament run-out sensor (Optional)
Before using this function, please check whether it is turned on or not. Choose
“Control”>”Filament”>“Runout sensors” and make sure it shows “ON”. See pictures (8-3, 8-4).
(Picture 8-3)
(Picture 8-4)
 It will pop up the notification “Err: No Filament” when the filament is run out during printing
and the printer will stop. See picture (8-5).