44
SHENZHEN GETECH TECHNOLOGY CO LTD
(Picture 6-30)
You can find the model information such as estimated print time, the amount of filament needed,
etc. Click “Print” to start USB printing. Refer to picture (6-31).
The printer will heat to the target temp and then start printing. Under high temperature, the
filament will flow out of the nozzle, which is normal. You can use tweezers to clean up the
residual material of the nozzle.
(Picture 6-31)
6.4 SD card printing
When all parameters are set, click “Save for SD print”. It will pop up a dialog as picture below
To Next Page
Loading...
