57
SHENZHEN GETECH TECHNOLOGY CO LTD
11.4 Layer shift
The printing speed is too fast. Please slow it down.
The belt of X or Y axis is too lose. Please tighten it.
The X or Y axis synchronization wheel is not fixed firmly. Please adjust the eccentric
nuts.
The voltage of the driver of X/Y axis is too low.
11.5 Print stopped
USB printing: the signal is interfered. Please copy the model to SD card and print via SD card.
SD card printing: the gcode file in the SD card is abnormal, please slice again.
The quality of the SD card is poor. Please try another SD card.
The power supply voltage in the area is not stable; please print after the voltage is
stable.
Visit our official forum for more information:
http://www.geeetech.com/forum/viewtopic.php?f=98&t=61864
12 Declaration
12.1 Terms
Please be advised of the following terms (the “Terms”) regarding this User Manual (this
“Manual”):
All information in this Manual is subject to change at any time without notice and is provided for
convenience purposes only. Geeetech reserves the right to modify or revise this Manual in its
sole discretion and at any time. You agree to be bound by any modifications and/or revisions.
Contact the Geeetech Support Team for up-to-date information.
12.2 Disclaimers
Neither Geeetech nor any of our affiliates warrants the accuracy or completeness of the
To Next Page
Loading...
Need help?
General
