53
SHENZHEN GETECH TECHNOLOGY CO LTD
(Picture 8-5)
Press the extruder handle, remove the remaining filament before loading the new filament.
When the filament is loaded, use a tweezers to clean the nozzle. Press the knob to enter the
main menu, and choose “Resume print” to re-start the printing. See picture (8-6).
(Picture 8-6)
8.4 3D touch for auto bed leveling (Optional)
This printer supports auto bed leveling. Refer to the link below to know how to install the 3d
touch sensor.
https://www.youtube.com/watch?v=_RtsZDbR2po&t=66s
Visit our official forum
http://www.geeetech.com/forum/
To Next Page
Loading...
