SHENZHEN GETECH TECHNOLOGY CO., LTD
22
• Preheat PLA: Manually pre-heat the hot bed and extruder before printing PLA.
• Preheat ABS: Manually pre-heat the hot bed and extruder before printing ABS.
(Picture 7-4) (Picture 7-5)
The main functions of Control menu (Picture 7-6, 7-7):
• Temperature: Change the temp of the hot bed and extruder in real time
during printing. Customize the temp of preheat PLA and preheat ABS.
• Motion: Motion parameter setting in firmware. After modification, choose
“store memory” to save the change.
• Filament: Open or close filament detector; set filament diameter.
• Store settings: Save the parameters modified.
• Load settings: If you need to restore to the original settings, please choose
this option.
• Restore failsafe: Restore factory setting.
• Initialize EEPROM: Initialize printer Settings
(Picture7-6) (Picture 7-7)
Test the motors’ function via LCD
Press the knob to enter the next menu; choose “Prepare”. See picture (7-8).
(Picture 7-8)
To Next Page
Loading...
