SHENZHEN GETECH TECHNOLOGY CO., LTD
41
• Be sure to clean the residue in the nozzle before restarting the print or it would affect the
quality of the print.
9.2 Reset button
The reset button is below the knob. When the printer works abnormally, press the reset button
to reset the printer to avoid any damage. See picture (9-2).
(Picture 9-2)
9.3 Filament run-out sensor (Optional)
Before using this function, please check whether it is turned on or not. Choose
“Control”>”Filament”>“Runout sensors” and make sure it shows “ON”. See pictures (9-3, 9-4).
(Picture 9-3) (Picture 9-4)
• It will pop up the notification “Err: No Filament” when the filament is run out during
printing and the printer will stop. See picture (9-5).
• Press the extruder handle, remove the remaining filament before loading the new filament.
• When the filament is loaded, use a tweezers to clean the nozzle. Press the knob to enter the
main menu, and choose “Resume print” to re-start the printing. See picture (9-6).
To Next Page
Loading...
