Geeetech A20 - 5.3 Check the power input mode; 5.4 Check the filament

SHENZHEN GETECH TECHNOLOGY CO., LTD
12
5.3 Check the power input mode
The factory default voltage is 230V. You need to choose the correct voltage according to your
local standard requirement. See picture (5-11)
Note: Be sure the voltage is switched to the correct one.
(Picture 5-11)
5.4 Check the filament
Put the filament on the spool holder. Please pay attention to the feeding direction of the filament.
See picture (5-12).