Content
1. Software Resources ..................................................................................................................... 1
1.1 Driver ................................................................................................................................. 1
1.2 Arduino IDE ....................................................Pogreška! Knjižna oznaka nije definirana.
1.3 EasyPrint 3D Installation and Configuration ....................................................................... 1
2. Hotbed Leveling .......................................................................................................................... 5
2.1Homing ............................................................................................................................... 5
2.2 Coarse Tuning of distance between the nozzle and the hotbed............................................. 6
2.3 Fine Tuning ........................................................................................................................ 7
3. Print Settings ............................................................................................................................... 8
3.1 Quick mode ........................................................................................................................ 8
3.2 Custom mode ..................................................................................................................... 9
3.2.1 Create a new configuration/setting ............................................................................ 9
3.2.2 Print settings ........................................................................................................... 10
4. Begin Printing ........................................................................................................................... 21
4.1 Load a Model File ............................................................................................................ 22
4.2 Print Setting...................................................................................................................... 22
4.3 Slicing .............................................................................................................................. 23
4.4 Stand-alone print with SD Card ........................................................................................ 24
4.4.1 Save Job ................................................................................................................. 24
4.4.2 Print ........................................................................................................................ 25
5. FAQ ........................................................................................................................................... 27
5.1 How to upgrade firmware? ............................................................................................... 27
5.2 How to change the motor direction in firmware? .............................................................. 30
5.3 User manual of Repetier Host ........................................................................................... 31
5.4 Possible causes for motor’s non-action ............................................................................. 31
5.5 Extruder does not work normally ...................................................................................... 31
5.6 The hotbed or extruder can not be heated .......................................................................... 31
5.7 LCD error: MAX/MIN TEMP error .................................................................................. 31
To Next Page
Loading...
