Geeetech Prusa I3 - Attach the Heatbed

Attach the heatbed
Required parts
Number
MK2BA heatbed
1
Borosilicate glass
1
Spring
4
M3 locking nut
4
Paper clip
4
M3-30 screws
4
1. Attach the borosilicate glass to the MK2A heatbed with paper clips
2. Attach the heatbed to the acrylic bed using m3-30 screws, springs, and m3 locking nuts. The
order is: m3-25 screw – heatbed – spring- acrylic bed – m3 locking nut. Repeat this for all four
corners.
3. Attach the thermistor to the center of the heat bed with a piece of tape or heat conducting
silicone