AVy -HGB
Ch.8 128
“Opt2-A” (Low Priority)
“PDC” (High Priority) Parameter available via the APC Card asynchronous communica-
tion (see the APC Card user manual) and/or the Process Data
Channel (PDC) of the Field bus.
NOTE: When field Bus interface parameters whose range is
[min=0; max=1] can be assigned to either virtual digital inputs
(if “w” access code exists) and/or virtual digital outputs (if “R”
access code exists).
IA, QA, ID, QD in the "Term." column The function can be accessed via a freely programmable analog or
digital input or output.
IA = analog input
QA = analog output
ID = digital input
QD = digital output.
The possibly present number is the one by which the terminal is
identified.
H, L in the "Term." column Level of the terminal signals (H=high, L=low) which enables the
single function.
R/W/Z/C Access possibilities via the serial interface, Bus or Opt2 manual or
asynchronous communication :
R = Read, W = Write, Z = Write only when drive disabled,
C=Command parameter (the writing of any value causes the
execution of a command).
X · Pyy The value of this parameter can correspond to min/max X times
the value of the yy parameter.
NOTE ! The parameter number shown in the following table is a base number. The value 2000H
(=8192 decimal) must be added to the number given in the “No.” column in order to
obtain the index to access the parametr via Bus, serial line or Opt2 (APC card). The
parameters in the Drivecom group can be accessed using the format and index specified
in the DRIVECOM power transmission profile (#21).
* When the parameter is accessed by Opt2-A/PDC the format is U16
** When the parameter is accessed by Opt2-A/PDC the format is I16
*** When the parameter is accessed by Opt2-A/PDC the lower word of the parameter is considered
To Next Page
Loading...
Need help?
General
