Genelec 9320A User Manual

9320 Reference Controller Operating Manual 19 (52)
 Press the INPUT key repeatedly to toggle through all the inputs
 When you leave a input selection in the display, this selection is applied after a time-out of about
one second
If you do not want to select a new input, press the MONO key to select ‘Cancel’ before the selection
time-out has passed. If you do not cancel, the currently displayed input gets selected.
Fig. 12. Example of selecting the analogue input – click the ANALOG key on 9320A. The analog input
shows in the display (left). After a short delay, the analog output gets selected (right) and turns on.
Fig. 13. The DIGITAL and USB audio input shown as selected and on.
5.4 Output keys: Selecting Audio Output
The audio output can be selected by pressing the keys for headphone, ANALOG and DIGITAL outputs.
Fig. 14. Selections for audio outputs in 9320A.
Select the output by pressing one of the following keys: headphone symbol, ‘ANALOG,’ or ‘DIGITAL.’
This shows the selected output in the display, the text next to the selected key turn on, and the selected
output audio turns on.
The mode of level control is shown after the output name as “9320 level control” when the 9320
Reference Controller is adjusting the level of the outgoing audio signal level when the volume level is
being adjusted.

Genelec 9320A Specifications

General

Brand	Genelec
Model	9320A
Category	Controller
Language	English