Genelec 9320A

9320 Reference Controller Operating Manual 47 (52)
Table 7. Typical system performance
Parameter Unit
AES/EBU
input to
headphone
output
AES/EBU
input to line
output
Line input to
line output
Line input to
headphone
output
Line input to
AES/EBU
output
Frequency response, – 3 dB point kHz 0 – 46 0 – 46 0,2 Hz – 46 0,2 Hz – 46 0,2 Hz – 46
Frequency response flatness,
measurement range 10Hz – 40 kHz
dB ± 0,1 ± 0,1 ± 0,1 ± 0,1 ± 0,1
Channel gain difference dB < 0,1 < 0,1 < 0,1 < 0,1 < 0,1
Dynamic range
Lo Gain
Hi Gain
dB 126
(250-600Ω)
126
121
118
121
118
123
121
Noise (A weighted), measurement
range 20 Hz – 20 kHz, (Vol. -0dBFS)
Lo Gain
Hi Gain
µV 3 3
5,5
7,5
5,5
7,5
n.a.
THD+N distortion and noise (Lo Gain),
maximum volume setting, input signal
-6 to 0 dBFS 1 kHz, measurement
range 20 Hz - 20 kHz
% < 0,0004 < 0,0004 < 0,0005 < 0,0005
< 0,0004
dB < –108 < –108 < –106 < –106 < –108
THD+N distortion and noise (Hi Gain),
maximum volume setting, input signal
-6 to 0 dBFS 1 kHz, measurement
range 20 Hz - 20 kHz
% n.a n.a < 0,0006 < 0,0006
< 0,0005
dB n.a n.a -104 -104
-106
Input to output latency ms 3,2 3,2 2,1 2,1
2,0
Crosstalk 10kHz -10dBFS
Load impedances
100 kΩ,
150 Ω,
32 Ω
* When using small headphone loads, most of the
crosstalk is caused by impedance of common
ground of TRS connector.
dB
-120
-87
-74*
-120 -120
-120
-87
-74*
-120