Generac Power Systems 0K8420-A User Manual

Installation Checklists
48 Installation Guidelines for Spark-Ignited Stationary Emergency Generators
 Are batteries correctly installed?
 Are the battery fluid levels correct?
 Are battery cables and connections clean and free of corrosion?
 Are the battery cables correctly connected? Are the terminal lugs correctly tightened?
 Is the battery condition and state of charge acceptable?
 Is area housing storage battery properly ventilated?
 Are batteries located near a source of flame or spark?
 Are AC wire sizes and connections correct?
 Are DC and communication wire sizes and connections correct?
 Are DC and communication wires routed separately from AC wires (per code)?
 Are block heaters, battery charger, etc. properly matched with utility supply voltage?
 Are battery charger and block heater properly connected?
 Are remote start Wires 178 & 183 pulled and connected inside lower control panel of generator and inside transfer
switch?
 Is the AUTO/OFF/MANUAL mode in the “OFF” position?
 Is the block heater operational?
 Is the battery charger operational?
 Are all AC electrical connections tight at the circuit breaker and transfer switch?
 Are all electrical connections (wiring, wire ties, clamps, terminal ends, connectors) on the generator tight?
 Are all electrical plugs throughout the generator seated correctly and fully inserted into their receptacles?
 Is there proper voltage and phase rotation at the transfer switch?
 Is manual operation of the transfer switch smooth and non-binding?
 Do these parameters meet all applicable codes and local jurisdiction?
8.8 — Oil Maintainer System Checklist
NOTE: See Section 7 for more information.
 Has the oil maintainer oil supply tank been filled with the recommended engine oil and tested?
 Has the oil maintainer been tested to the proper level?

Generac Power Systems 0K8420-A Specifications

General

Brand	Generac Power Systems
Model	0K8420-A
Category	Portable Generator
Language	English