General Information
20 MGG100M Operating Manual 36833 C
Manual Shut-Off
To manually interrupt power between the generator and connection lugs, use the disconnect lever on the customer
disconnect switch box (Figure 13).
Figure 13 - Disconnect Lever
EMISSIONS
The United States Environmental Protection Agency (US EPA) (and California Air Resources Board (CARB), for
engines/equipment certified to California standards) requires that this engine/equipment complies with exhaust and
evaporative emissions standards. Locate the emissions compliance decal on the engine to determine applicable
standards. For emissions warranty information, please reference the included emissions warranty. It is important to
follow the maintenance specifications in the manual to ensure that the engine complies with the applicable emissions
standards for the duration of the product’s life.
FUEL SYSTEM
Note: The ignition is factory set to 18° BTDC.
Verify timing set correctly to 18° BTDC. Failure to do so could result in irreparable damage
to the unit.
This is a dual-fuel generator, capable of running on either natural gas—wellhead or refined (NG), or propane liquid
(LPL). The unit runs on either fuel source, but never simultaneously. Each fuel source is connected to an independent
fuel system. Fuel switching occurs automatically and during unit operation—no operator action is required. For more
information, see Fuel Switching.
ALL FUEL TYPES ARE POTENTIALLY FLAMMABLE AND/OR EXPOSIVE AND
SHOULD BE HANDLED WITH CARE. COMPLY WITH ALL LAWS REGULATING THE
STORAGE AND HANDLING OF FUELS.
02258
To Next Page
Loading...
Need help?
General
