Maintenance
50 MGG100M Operating Manual 36833 C
Changing Engine Oil and Filter
WARNING
Potential of cancer. Prolonged or repeated contact with used motor oil has been
shown to cause cancer in laboratory animals. Thoroughly wash exposed areas with
soap and water. (000127a)
When changing oil, it is not necessary to drain oil from reservoir.
1. Stop engine and let cool for at least 10 minutes.
2. Close valve below oil reservoir.
3. Place a container below oil drain port.
4. Remove oil drain plug.
5. Open drain valve at the engine oil pan. Verify oil level regulator valve is open.
6. Allow oil to drain completely into the container.
7. Remove oil filter and discard it. Gasket from filter might separate and become stuck to the engine. If so,
remove the gasket and discard it.
8. Before installing new oil filter, lubricate oil filter gasket with a thin film of clean engine oil.
9. Install new oil filter, turning one full turn after initial gasket contact.
10. Close engine oil drain valve and reinstall plug at the skid frame drain port.
11. Remove oil fill cap on engine valve cover and add fresh oil. See General Information for oil capacity and oil
type.
12. Check the oil dipstick. Oil level should be between ADD and FULL marks.
13. Open oil reservoir valve.
14. Top off the oil in the reservoir.
There is no need to run the unit and re-check the oil level. The filter automatically fills up with oil and the oil switch
allows the proper amount of oil to supply the engine until full.
Engine Coolant
ETHYLENE GLYCOL BASE ANTIFREEZE IS POISONOUS. DO NOT USE MOUTH-TO-
SIPHON COOLANT FROM THE RADIATOR, RECOVERY BOTTLE, OR ANY CON-
TAINER. WASH HANDS THOROUGHLY AFTER HANDLING. NEVER STORE USED
ANTIFREEZE IN AN OPEN CONTAINER BECAUSE ANIMALS ARE ATTRACTED TO
THE SMELL AND THE TASTE OF ANTIFREEZE EVEN THOUGH IT IS POISONOUS.
DO NOT USE ANY CHROMATE BASE RUST INHIBITOR WITH PROPYLENE GLYCOL
BASE ANTIFREEZE. USING ANY HIGH SILICATE ANTIFREEZE BOOSTERS OR ADDI-
TIVES WILL CAUSE OVERHEATING. THE MANUFACTURER RECOMMENDS THAT
NO SOLUBLE OIL INHIBITOR BE USED FOR THIS EQUIPMENT.
To Next Page
Loading...
Need help?
General
