36833 C MGG100M Operating Manual 27
Section 3 - Operation
This section assumes the unit has been properly configured, serviced, tested, adjusted, and otherwise prepared for
use. The owner is responsible for ensuring the emission control system complies with state and local regulations.
Note: The unit should be configured, serviced, tested, and adjusted by a GMPASD.
OPERATOR GUIDELINES
The unit should be operated only by an authorized operator. An authorized operator is someone trained by a GMPASD.
For information on training and authorizing operators, contact a GMPASD. Operators should read and understand
this manual before operating the equipment.
WARNING
Consult manual. Read and understand manual completely before using product.
Failure to completely understand manual and product could result in death or serious
injury. (000100a)
Note: Contact Generac Mobile Products Technical Service if you have any questions.
The procedures in this manual are suggestions. The owner/operator is responsible for ensuring these procedures
are executed by licensed contractors according to all applicable codes.
In addition to these suggestions, before installing the unit, you should obtain the most up-to-date copies of the
following documents from the National Electrical Code and other authorities.
• National Electric Code, articles 230, 250, 445, 517, and 700
• National Fire Protection Association:
No. 30: Storage, Handling and Use of Flammable Liquids
No. 37: Stationary Combustion Engines and Gas Turbines
No. 99: Essential Electrical Systems for Health Care Facilities
No. 101: Life Safety Code No. Systems
No. 110: 1985 Emergency and Standby Power Systems
•NEMA MG1
• Local codes applicable to genset installation (see your local building inspector)
NFPA (National Fire Protection Association) (617) 770−3000 (includes NEC)
1 Batterymarch Park, Quincy, MA 02169−7471 USA
NEMA (National Electrical Manufacturers Association) (703) 841−3200
1300 N. 17th Street, Suite 1847, Rosslyn, VA, 22209 USA
To Next Page
Loading...
Need help?
General
