Generac Power Systems Power Zone Pro Sync User Manual

38 Owner’s Manual for Power Zone Pro Sync
Troubleshooting
REPLACE OIL The time frame set for oil life
maintenance has been
exceeded. Change the oil.
The date or engine hours
exceed the specified limits
set for oil life.
Change the limits for oil
life using the Display
after replacing the oil.
REPLACE OIL
FILTER
The time frame set for oil filter life
maintenance has been
exceeded. Replace the oil filter.
The date or engine hours
exceed the specified limits
set for oil filter life.
Change the limits for oil
filter life using the
Display after replacing
the oil filter.
REPLACE SPARK
PLUG
The time frame set for spark plug
life maintenance has been
exceeded. Replace the spark
plugs.
The date or engine hours
exceed the specified limits
set for spark plug life.
Change the limits for
spark plug life using the
Display after replacing
the spark plugs.
REPLACE AIR
FILTER
The time frame set for air filter life
maintenance has been
exceeded. Replace the air filter.
The date or engine hours
exceed the specified limits
set for air filter life.
Change the limits for air
filter life using the
Display after replacing
the air filter.
REPLACE
BATTERY
The time frame set for battery life
maintenance has been
exceeded. Replace battery.
The date, number of crank
cycles, or engine hours
exceed the specified limits
set for battery life.
Change the limits for
battery life using the
Display after replacing
the battery.
GENERAL SERV
REQ
The time frame set for general
service exceeded. Check system
for regular maintenance.
The date or engine hours
exceed the specified limits
set for general service.
Change the limits for
general service using
the Display after
confirming maintenance
checks.
XFER SWITCH
UTIL MAINT
The time frame set for utility
transfer switch maintenance
has been exceeded. Service
the utility transfer switch.
The date, number of
transfers to utility power, or
engine hours exceed the
specified limits set for utility
transfer switch life.
Change the limits for
utility transfer switch life
using the Display after
servicing the utility
transfer switch.
XFER SWITCH
GEN MAINT
The time frame set for generator
transfer switch maintenance has
been exceeded. Service the
generator transfer switch.
The date, number of
transfers to generator
power, or engine hours
exceed the specified limits
set for generator transfer
switch life.
Change the limits for
generator transfer switch
life using the Display
after servicing the
generator transfer
switch.
TASK TIMEOUT One or more functions in the
firmware is not completing its task
in a timely manner or is getting
stuck completely. This could
happen due to too much electrical
noise around the controller, too
many controller interrupts, the
processor has failed or become
corrupted, or other reasons.
The watchdog circuit was
not serviced within the
required period of time.
Turn keyswitch to OFF.
Clear the alarm using
the Display.
TASK EXIT A Main Controller operating
system task exited unexpectedly.
A Main Controller operating
system task was incorrectly
terminated.
Power cycle the Main
Controller and clear the
alarm using the Display.
Alarm Display Text Description Set Alarm Clear Alarm

Generac Power Systems Power Zone Pro Sync Specifications

General

Brand	Generac Power Systems
Model	Power Zone Pro Sync
Category	Controller
Language	English