HT Series II Inert Gas Purge
10-1474 Issue 3-6 March 2014 11
Maintenance
Any repair of this product must be carried out by Genevac personnel or by an approved
representative of Genevac, using only Genevac approved spare parts.
Periodic maintenance
Check the condition of the hoses weekly. Make sure the hoses are securely fitted, are not
blocked and are free from kinks or sharp bends that could affect the flow of fluid.
When operating the evaporation system, periodically check the purge time and
must run time are as specified in the Technical Data section. If the times are outside the
specified limits, do not use the inert gas purge system, contact Genevac Service Department
for advice.
To Next Page
Loading...
