Genevac HT-4X - EC Declaration of Conformity

User Manual
HT Series II Inert Gas Purge
10-1474 Issue 3-6 March 2014 21
EC Declaration of Conformity
EC Declaration of Conformity: HT-8SII & HT-12SII Evaporators
Manufacturer’s Name:
Genevac Ltd
Manufacturer’s Address:
Farthing Road
Ipswich
Suffolk
IP1 5AP
UK
Type of Equipment:
Laboratory Equipment
This is to certify that the following products (including inert gas purge systems where fitted):
HT-8SII, all variants including
VC6000 condenser and nXDS6i vacuum pump
HT-12SII, all variants including
VC6000 condenser and nXDS6i vacuum pump
Conform to the Essential Health and
Safety requirements of European
Directives:
 Machinery Directive (2006/42/EC)
 EMC Directive (2004/108/EC) and
 Low Voltage Directive (2006/95/EC)
A technical construction file for this product is held at the above address
Individual declarations are available on request
Conformity is demonstrated by
compliance to the following standards:
BS EN 61010-1:2010 Safety requirements for electrical

equipment for measurement, control, and laboratory use. General
requirements.
BS EN 60204-1:2006 + A1:2009 Safety of machinery.

Electrical equipment of machines. General requirements.
BS EN 61326-1:2006 Electrical equipment for measurement,

control and laboratory use. EMC requirements.
BS EN 12100:2010 Safety of machinery. General principles

for design. Risk assessment and risk reduction.
BS EN 378-2:2008 + A1:2009 Refrigerating systems and

heat pumps. Safety and environmental requirements. Design,
construction, testing, marking and documentation.
This equipment is considered Class A industrial equipment according to EN6132 / CISPR 11 and is intended for use in a
laboratory environment. In non-laboratory environments this product might cause interference, in which case the user is
required to take appropriate actions.
Signed:
Name:
G Broadbent
Position:
Research and Development Manager
Date:
18
th
December 2013
Being the person appointed by Genevac Ltd to sign on their behalf