Genicom LA36 - Character Set Control; Color Selection

C-24
Command Sets
Function Command
Vertical tab execution VT
Set vertical tabs ESC B (n
1
) ... (n
k
) NUL
The values of n
1
to n
k
in this command are the
ASCII values of the lines (at the current line
spacing) at which tabs are to be set.
(1 ≤ n ≤ 255) (1 ≤ k ≤ 64)
Clear all vertical tabs ESC B NUL
Reset tabs to default values ESC R
Page Formatting
Set left margin at column n and right ESC X (n) (m)
margin at column m (0 ≤ n, m ≤ 255)
Set perforation skip by n lines ESC N (n)
(1 ≤ n ≤ 255)
Perforation skip off ESC O
Set page length to n lines (1 ≤ n ≤ 255) ESC C (n)
Set page length to n inches (1 ≤ n ≤ 22) ESC C NUL (n)
Set top of form ESC 4
Color Selection*
Select print color* ESC r (n)
n = 0: Black
1: Magenta (red)
2: Cyan (blue)
3: Violet
4: Yellow
5: Orange
6: Green
Character Set Control
Select character set 1 ESC 7
Select character set 2 ESC 6
Print n
1
+ n
2
X 256 characters from all-character set ESC \ (n
1
) (n
2
) (chars.)
(chars.: codes of characters to print,
0 ≤ chars. ≤ 255)
Print a character from all-character set ESC ^ (char.)
(char.: a code of character to print,
0 ≤ char. ≤ 255)