4-30
Using Set-Up Mode
Changing Menu Access Options
You can restrict the access to the Set-Up functions to avoid accidentally changing the Set-
Up options.
MENU ACCESS Option and Values
• Overprinted values are the factory settings.
MENU ACCESS
Option Values Description
<MENU-ACCES> Specify the type of access to the Set-Up functions
from the control panel or from the <FUNCTIONS>
menu.
ALL FUNC All functions are accessible.
MACRO ONLY Only MACRO 1 and MACRO 2 functions are
accessible from the <FUNCTIONS> menu.
NO ACCESS Set-Up mode is inaccessible.
NO PANEL
Font, Macro, and Protocol buttons are disabled even in
Normal mode. Set-Up mode is also inaccessible.
Note:
You can return to the All Functions Accessible
mode by turning the printer on while pressing the
Park, LF, and FF/Load buttons at the same time.
The printer enters the Set-Up mode with this
operation.
Exiting and Saving
This section describes how to exit the Set-Up mode while saving any changes you have
made.
To exit the Set-Up mode with the settings saved, first select the SAVE&EXIT function and
then press the button or the button.
Any settings changed while in the Set-Up mode are saved as the new power-on defaults for
the printer. The new defaults remain active until you change them again.
To Next Page
Loading...
