Genicom LA36 - Control Panel Operations

2-5
Paper Handling
Control Panel Operations
— : This operation has no connection with this condition.
N/A : The condition does not apply because this operation is executed before powering
on.
Operation Required Conditions
*1
Required Action
Ready Printing
*2
Fault
Load continuous forms paper — Not printing On Press FF/Load.
Load single sheet paper — Not printing On Press FF/Load if single sheet
load is switched from AUTO
to MANUAL in Set-Up mode.
Feed paper a page — Not printing Off Press FF/Load.
Feed paper a line — Not printing Off Press LF.
Advance perforation to tear bar — Not printing Off Press Pause if the TEAR
option is switched from AUTO
to MANUAL in Set-Up mode,
or press FF/Load.
Advance paper for viewing — Not printing Off Press Pause if the TEAR
option is switched from AUTO
to MANUAL in Set-Up mode.
Return paper to previous position — Not printing Off Press Pause if the TEAR
option is switched from AUTO
to MANUAL in Set-Up mode,
or press FF/Load.
Eject single-sheet paper — Not printing Off Press FF/Load or Park or turn
the printer off and on again.
Unload continuous-forms — Not printing Off Press Park.
paper
*3
Pause printing On Printing Off Press Pause.
Resume printing Blinking Not printing Off Press Pause.
Resume printing after a fault Off Not printing On Clear error and press Pause.
Resume printing after paper-out Off Not printing On Load paper.
Place printer in Ready state Off Not printing Off Press Pause.
Place printer in pause state On — Off Press Pause.
Enter Normal mode N/A N/A N/A Turn power on without
pressing any buttons
Printing test N/A N/A N/A Turn power on while pressing
FF/Load.