Total Station Manual
ƻ
4
Move the prism just
standing below the remote
point, then aim at the bottom
of prism rod and press [F1]
(ALL)or[F2]+[F3](DIST
+ REC) to finish the base
point measuring.
[F1] or
[F2]+[F3
]
ƻ
5
Turn the instrument
telescope aimed at prism and
press [F4] to measure the
prism high. Then enter the
[REM PT] window.
[F4]
ƻ
6
Turn the instrument
telescope aimed at remote
point and press [F4] to finish
current remote point
measuring. Press [F1] to
re-set the base point.
[F4]
11. COGO
COGO(Coordinate Geometry)is an application used to perform coordinate
geometry calculations by the preset conditions such as , coordinates of points,
bearings between points and distance between points.
The COGO calculation methods include:
Inverse and Traverse
Intersections
Offset
Extension
11.1 Traverse
Use the traverse subapplication to calculate the plane coordinate of a new
pointusing the bearing and distance from a known point. Offset is optional.
To Next Page
Loading...
