Total Station Manual
61
the point is found, press [OK] in
the [Find Pt.] list screen to set it
as station. Program enter input
instrument height screen. If the
point doesn’t exist, press
[F3](Coord.) to input the
coordinates of N, E and Z. Set
this point as station.
[Zero]: Set this point’s all
coordinates as 0 and set the
point as station.
[Coord.]: Enter [Input Coord.]
screen. Input the coordinates
and save them to the current job.
Back OK
ƻ
4 Enter input instrument
height screen. Input the
instrument height and press
[ENT] to confirm. Then press
[F4](OK) to save and set the
station informations.
Press [ESC] then back to
previous screen. Continue to set
the coordinates of station.
Input
instru
ment
height
+
[ENT]
+
[F4]
ƻ
5 Back to Pre-Settings screen.
The setting items that have been
made are marked with *.
Ć
1
: The details of [Find Pt.] can be found in the chapter “Find Point”. You can also
input the wildcard "*" to search all the points.
2.2 Select the Fix Point in the Memory [List]
User can select the fix point in the memory's jobs to set station without inputting
the point name.
Steps Key Display
To Next Page
Loading...
