Total Station Manual
27
refer to “Technical Parameters”.
Steps Key Display
ƻ
1
After entering to the
interface of EDM
Setting,using the direction of
Ę
to move the cursor to the
setting item of Reflector.
Ę
ƻ
2
Press
ĕė
to select the
types of reflector. Each time
you press
ĕ
or
ė
, the type of
reflector is switched.
ĕ
ė
ƻ
3 After finished setting,
press [F3] (OK) to return the
function of Q-Surveying.If
you want to cancel the
settings, press [ESC] to ignore
the changes.
[F3]
Set up the Reflecting Prism Constant.
As a prism is selected as a reflector, a prism constant should be set before any
measurement. If the constant is entered and set, it is saved and will not be erased after
switching off the instrument.
Example: Prism Constant is -30mm
To Next Page
Loading...
