Total Station Manual
57
ƻ
2
Press [F2](New) and then
enter the Create a New Job
screen.
Press [F4](OK), the displayed
job will be set as current job
and then back to Pre-Settings
screen.
[F1]
ƻ
3 If the instrument is fitted
with SDCard, there willfirstly
showthe diskselection screen.
In this screen, user can select
the disk through Up or Down
key. Then press [F4](OK) to
confirm.
A: Local Disk
B: SD Card
ƻ
4
Continue to show New Job
screen. Input the new job’s
name, operator, etc. Press
[ENT] to finish one input item
and thecursor moves to the
next input itemautomaticallyat
the same time.
Ć
Input
job’s
data
+
[ENT]
ƻ
5
Press [F4](OK) to
complete setting a new job
after finishing all the inputs.
This job will be set as the
current job. Then back to the
Pre-Settings screen.The
completed setting item is
marked with [*].
[F4]
To Next Page
Loading...
