Total Station Manual
65
Steps Key Display
ƻ
1 Press [F3] in the
Pre-Settings screen. Then
enter the Set STA function.
[F3]
ƻ
2
Press [F1] and select the
[Angle Setting] to input
orientation manually.
[F1]
ƻ
3 Aim B.S. point and then
input the azimuth, prism
height and backsight point
name. Press [ENT] after
finishing every input.
Input
horizontal
angle
+
[ENT]
ƻ
4 Press [F1](ALL) to start
measuring and set the
orientation.
[REC]: Press this key to
finish setting orientation
without measurement.
[Zero]: Set the azimuth as 0.
[F1]
To Next Page
Loading...
